Skip to main content

Projectors

We have six Barco XDL-4K30 projectors and one Barco F90-4K13-3D projector in the Dome.

  • Projector 1:
    • DNS:
    • IP: http://172.19.7.31:9999/
    • Projector Placement: On a table, near the RWC, in the North-West corner of the building.
    • Chiller Placement: Above the RWC, on the Pre-Show roof to the North-West.
    • Projection Area: Straight ahead and to the left, along the Dome rim.
  • Projector 2:
    • DNS:
    • IP: http://172.19.7.32:9999/
    • Projector Placement: On a table, In the North-East corner of the building.
    • Chiller Placement: On the Pre-Show roof, to the North-East.
    • Projection Area: Straight ahead and to the right, along the Dome rim.
  • Projector 3:
    • DNS:
    • IP: http://172.19.7.33:9999/
    • Projector Placement: On the floor, in the South-East corner of the building.
    • Chiller Placement: Down stairs on a shelf, first one when entering the tech corridor.
    • Projection Area: Straight backwards and to the right, along the Dome rim.
  • Projector 4:
    • DNS:
    • IP: http://172.19.7.34:9999/
    • Projector Placement: On the floor, near the elevator, in the South-West corner of the building.
    • Chiller Placement: Down stairs on a shelf, second closest to the elevator room door.
    • Projection Area: Straight backwards and to the left, along the Dome rim.
  • Projector 5:
    • DNS:
    • IP: http://172.19.7.35:9999/
    • Projector Placement: On the floor, in the North-East corner of the building.
    • Chiller Placement: On the Pre-Show roof, to the North-East.
    • Projection Area: Towards the top/cap, slightly forward and to the right.
  • Projector 6:
    • DNS:
    • IP: http://172.19.7.36:9999/
    • Projector Placement: On the floor, near the elevator, in the South-West corner of the building
    • Chiller Placement: Down stairs on a shelf, closest to the elevator room door.
    • Projection Area: Towards the top/cap, slightly backwards and to the left.
  • Projector 7 (Insert):
    • DNS:
    • IP: http://172.19.7.37:9999/
    • Placement: Above the control booth, access via elevator or ladders.
    • Projection Area: Straight a head

For more generic information, look at Projector - Assumptions

Old information from Evernote (Needs fixing)…

Web-site with overview of the matrix:  https://c-zabbix2.itn.liu.se/barco/

This page can be accessed from anywhere.

First part is the decoders, second part the encoders.

If all the decoders with name/unit "Proj..." (D1-D12) are green on resolution:4096x2160p60 and state:OK, the the projectors should be ON. If it's red and resolution is "0x0" the the projector is OFF.

The WebPanel/Medialon GUI can be accessed with this adress: http://172.19.6.6

Currently HostPanel is the one used for everybody, including us technicians.

Their you can on the "Projector" tab see if the status of all projectors as well, and try to start them a second time for instance (it does not matter if some are already started when you send On to everybody).

If their is something wrong with a projector, you can access each projector in above urls.

If the webpage is not responding, the power of the projector needs to be pulled for 1 minute, then start it up again.

Websites ( http://172.19.6.231/,  http://172.19.6.232/,  http://172.19.6.233/,  http://172.19.6.234/) have remote power switches for all projectors, if needed.

If it is responding but in "Ready mode" try starting it again. If it fails, try do shut it off such that it goes into Standby mode, then start it again. If there is still errors, the power should pulled as explained above.

First part of the encoder section (S1-S13) is all the encoders for the BRAVO cluster. They should be green all the time, if not, something is wrong, and either the computer or the encoder should be rebooted. Start with the encoder, web adress is 172.19.7.UnitNr(51 for BRAVO-0 for instance). Reboot button is under Administration in that web page.

Also important to check that Encoder S27 is green (a FULL HD screen for FISHY computer) and that all Sushi encoders are green (even number S28, 30, 32, 34, 36) so for instance Adventure Dome can be started properly.